Drawbar For Enco 9x42

[Slayer_MN1]

Hey all, I recently acquired this 9x42 Enco and am in need of a drawbar, can you tell me what length I need to order?



Thanks

Steve

 

[Silverbullet]

You could measure the tube depth of the spindle , I'd hold a collet in and measure from the top down then I'd add an inch , not real hard to figure out . I'll bet it's around 20" or so 21" sounds right but ck it.

 

[Doubleeboy]

Call Dorian up and tell em you have a step pulley Enco head and want a draw bar. They make the best and supply darn near every retailer that sells USA made drawbars.

michael

 

[turnitupper]

A coupling nut welded to all thread, trim to length. Simple and cheap.
John.