- Joined
- Dec 6, 2012
- Messages
- 2,709
It's not as though I don't have enough stuff to learn!
I picked up this CutterMaster HDT-610 off CL for $500 came with 15 5C collets and an air spindle.
Wasn't really looking for an end mill sharpener. But, the price seemed right and it was close enough to have a look.
I found a free manual for a CutterMaster CM on line.
Does anyone have a manual for a HDT-610?
Please note that the design seems to be different from anything else I've been able to find as both the X and Y control handles are both on the front.
Perhaps they changed the design because the cable falls off?
In addition to needing to learn how this thing works, the cable driven Y axis is off the pulley.
Haven't begun to think through table dis-assembly yet.
Any/All suggestions/rebukes welcome.
Thank you,
Daryl
MN
I picked up this CutterMaster HDT-610 off CL for $500 came with 15 5C collets and an air spindle.
Wasn't really looking for an end mill sharpener. But, the price seemed right and it was close enough to have a look.
I found a free manual for a CutterMaster CM on line.
Does anyone have a manual for a HDT-610?
Please note that the design seems to be different from anything else I've been able to find as both the X and Y control handles are both on the front.
Perhaps they changed the design because the cable falls off?
In addition to needing to learn how this thing works, the cable driven Y axis is off the pulley.
Haven't begun to think through table dis-assembly yet.
Any/All suggestions/rebukes welcome.
Thank you,
Daryl
MN
Last edited: