Thanks- after a 706 mile round trip drive pulling a rented trailer, I finally managed to get it home and unloaded thursday night.
I haven't had a chance to really check it out yet... when I do, I'll post a few more pics.
It is a #2ML universal mill... supposed to be fully operational, but I did not get to test it under power, so it was sort of a gamble.
It is very nasty, but seems to be tight, with no excessive play in any axis.
One issue that I will have to deal with is that it is set up to be run on 440v 3 phase... the tag inside the door says 'main motor 220v 3 ph, controls 110v'... maybe I can figure it out...
-Bear
