I bought this R8 collet chuck set 20 years ago but don't remember where, and I can find no reference to it on the web, using the identifiers on the package set. There's seven collets ranging from 1/4in to 1in. I believe it's Asian, but It's very nice quality none the less, and holding up very well after 20 years of use. There's no reference to whether theses are ER32 collets or what.
I'd like to buy an mt3 collet chuck for my lathe and make use of the same collets, but can't identify the make, model, ER32 or not, etc.
Does anyone know if R.F.T. is simply gone or became somebody else?
Further, can anyone advise if these look like ER32 collets, how standardized they are, and how likely any new such collets will fit my current collet chuck?
I'd like to buy an mt3 collet chuck for my lathe and make use of the same collets, but can't identify the make, model, ER32 or not, etc.
Does anyone know if R.F.T. is simply gone or became somebody else?
Further, can anyone advise if these look like ER32 collets, how standardized they are, and how likely any new such collets will fit my current collet chuck?
