Anyone have a .stl file?

[COMachinist]

Looking for a .stl file or g-code file of a good BXA tool holder for a PM 12x36T back splash. I have looked on Thingiverse, and a few other places, and yes I have tried my hand at Fusion 360 design. I’m new at the 3d printing thing and just not coming up what I want. I just can’t find a good useable printed dovetail mount that will fit on the weird back splash. I have looked at the one on eBay but I can’t see paying $15-24 for a pre printed holder. I have a DIN rail, and aluminum angle but they rattle to beat heck sometimes when I’m doing an unbalanced, interrupted cut, and it is nerve racking to say the least. I know I’m cheap old fart. Any help will be greatly appreciated as always.
Thanks
CH

 

[Tio Loco]

I still have the stl for this one... mounted to plywood above the backsplash. Personally, I like having it up out of the direct path to swarf and coolant .

 

[Tio Loco]

Oops, sorry, this is AXA...

 

[7milesup]

I have a file but also for AXA. Mine clips on the back of the splash guard. I could draw you one up if I had dimensions...

 

[Bob Korves]

I did mine much more simply and quickly. Still does the job...

Magnetic tool holder

I am in the process of re-arranging and organizing my garage and considered getting a magnetic tool bar to hold all my CXA tool holders. However that got me thinking that my CXA tool holders would then become magnetized and start attracting every little bit of ferrous metal that shows up near...

www.hobby-machinist.com

 

[COMachinist]

Well I want to thank every one. I‘ll just work something out.
CH

 

[Mitch Alsup]

Looking for a .stl file or g-code file of a good BXA tool holder for a PM 12x36T back splash. I have looked on Thingiverse, and a few other places, and yes I have tried my hand at Fusion 360 design. I’m new at the 3d printing thing and just not coming up what I want. I just can’t find a good useable printed dovetail mount that will fit on the weird back splash. I have looked at the one on eBay but I can’t see paying $15-24 for a pre printed holder. I have a DIN rail, and aluminum angle but they rattle to beat heck sometimes when I’m doing an unbalanced, interrupted cut, and it is nerve racking to say the least. I know I’m cheap old fart. Any help will be greatly appreciated as always.

I made a few BXA sized holders {for dial indicators} and what I did to ensure correct fitment, it to use the tool-post to check fit while part is still in the vise on the mill.

With this strategy, all one needs is the dove-tail cutter, and to sneak up on the dimensions.