- Joined
- Jun 5, 2023
- Messages
- 108
So I accidentally hit my Z axis power feed while the gibs were locked and did not notice until "What's that smell?". Smoked that motor. Today's stupid fee.
I am hoping there is someone here that has done a CNC conversion and still has their power feed motor laying around if so equipped.
I can not find a US based seller of the motor and or motor gear box assembly, other than PM for these motors. Giving them a call tomorrow to see how big a stupid fee this will be.
Open to suggestions for alternates.
Can't find a 220v axis power feed (X,Y,Knee Z), at least not on the sub $400
I am hoping there is someone here that has done a CNC conversion and still has their power feed motor laying around if so equipped.
I can not find a US based seller of the motor and or motor gear box assembly, other than PM for these motors. Giving them a call tomorrow to see how big a stupid fee this will be.
Open to suggestions for alternates.
Can't find a 220v axis power feed (X,Y,Knee Z), at least not on the sub $400