Amazing video....Like cutting cheese!!!

S

sic semper tyrannis

Active User
Registered
Who knew there was so much deformation and flow going on at the cutting tip?

[video=youtube;mRuSYQ5Npek]http://www.youtube.com/watch?feature=player_embedded&v=mRuSYQ5Npek#![/video]
 
Gives you just a bit more respect and insight when you are out in the shop making chips!

It is almost hypnotic the way it builds and flows and shears and flexes.
 
Who cut the cheese? :lmao:

Neat video. In the first segment: That loading up, followed by chip release, then a different cut depth is what I always suspected gave a poor finish on CRS.

John
 
that was kewl
almost looked like it was flowing at times then at times the edge was not even doing the cutting
thanks
steve
 
Notice the lack of build-up with the high speed tool bits. That's why they produce such a good surface finish compared to carbide.

Tom
 
Thanks so much for pointing this out I will add it for my students.

Not as cool as the one you posted but this one shows an end mill in slow motion. You can see the chips forming.

[video=youtube;8D5TFxR7WIc]http://www.youtube.com/watch?v=8D5TFxR7WIc&feature=relmfu[/video]

Jeff
 
You must log in or register to reply here.
Back
Top