- Joined
- Jan 4, 2021
- Messages
- 930
The 2HL I just acquired were missing both the left and right hand table trip dogs. I figure I will just make replacements when the time comes.
I am looking for dimensions that I can create a drawing from in Fusion 360.
If you have a similarly sized mill (not sure if the 2H or larger would use the same parts as a 1H or 2HL), could you take a few minutes to sketch up some dimensions? I only have a rough idea of what they look like.
I am looking for dimensions that I can create a drawing from in Fusion 360.
If you have a similarly sized mill (not sure if the 2H or larger would use the same parts as a 1H or 2HL), could you take a few minutes to sketch up some dimensions? I only have a rough idea of what they look like.