1/2" brazed carbide boring bar for PM 2-inch boring head

[Rhizome]

Hello,
I'm looking for recommendation for 1/2-inch boring bar with brazed carbide that works well with the PM 2-inch boring head. I plan to use it to bore the arbor hole in saw blade plates from 5/8" to 30 mm to use with European table saw (30 mm arbor, 2 pins).
Thanks.

 

[Martin W]

30mm with 2 pins is a standard Altendorf arbor. Any carbide boring bar should work The carbide boring bar will not be as important as keeping everything concentric. Especially on a 350mm or 400 mm blade.
Be careful putting any carbide blade on your saw. Most 5/8" arbor blades were not meant to be used on a 10hp saw. 12" mitre saw blades have a negative rake so they also will not work.
cheers
martin