sieg

Great machines are not necessarily the best machines, but machines that reach the greatest audience. In this regard, one can say that the Atlas lathes were some of the most successful machines of all times. If I remember correctly, over half million were produced between the late 30s and the...

Hi, I bought a Seig C3 lathe to play around with and convert to a CNC lathe. It has a 4" faceplate with a three hole pattern and an MT4 spindle bore. But all of my existing chucks have 1" or 1.125" x 8 TPI female threads. I have been searching for a faceplate I can bolt on that has a male 1"...

I needed a spider for my SIEG SC4 (LMS 3540) lathe. It turns out the classic mini-lathe spindle terminates with the same thread, and so the LMS mini-lathe spider fits on nicely. Clearance from the spider body to the SC4's default 41 toothed gear is 13 mm, and the picture shows what the...

Hi guys, Hoping someone can help. Brought my SC2 out of the shed where it has been sitting for a while and it originally wouldn't turn on. Getting power and the green light would turn on but two secs later the fault light would too (no spinning). Read somewhere that the potentiometers inside are...