sheldon

  1. 63a7d7af-c847-4095-b255-ae680116ed68.jpg

    63a7d7af-c847-4095-b255-ae680116ed68.jpg

    My new Sheldon TE-1248P 12 inch by 48 inch 1200 lbs
  2. D

    Sheldon L vs XL - Part Swap

    Going through my recent purchase of a 10in Sheldon L series (Model num UL-44B) i have found i am not a huge fan of the rotating clutch for the power feed. ebay has a apron casting and assembly for a 10in XL lathe, which would effectively convert mine to the throw-lever style clutch 2-pice...
  3. D

    Sheldon 5C Collet Adapter Early R-Series 2017-09-11

    5C Collet Adapter with the "4-3/4" Morse taper. This is for all the older R series lathes with 1-7/16 or 1-1/2 spindle bores with either L-00 or 2.375-8 spindle nose. For most Sheldon lathes made before serial number 26000 give or take. Will not work with the later R series lathes with 2-1/4...
  4. E

    5C spindle adapter Sheldon UM-56-P 13" swing

    Hi folks, I have a question about my lathe that I seem to get a lot of conflicting information on when I scour the internet. It's about the spindle taper dimensions. It's really unclear what exactly I need to suit my needs with regards to a 5C spindle adapter. I have read countless times that...
  5. J

    Sheldon Sebastian 13" Gear Head Headstock Issue

    I have spent most of my time over on the yahoo forum... so I hate to duplicate questions but I am in need of assistance... At this point in my restoration I have the QCGB off and getting ready to replace a broken gear, I replaced the pulley on the motor and changed out the belts. The only...
Back
Top