-
Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!
motor starting
-
Enco Mill - motor takes a few tries to get to full speed
Hello experts, I have my Enco mill (RF30) up and running and have an annoying problem. When I turn the switch (forward or reverse, doesn't matter), the motor immediately kicks on and comes up to about 1/3 speed, then stalls or "pulses" at about that speed. It must pull a ton of current, as I...- tcweb
- Thread
- enco motor starting rf30
- Replies: 56
- Forum: ALL ABOUT ELECTRICAL ISSUES
-
Atlas Craftsman 12" lathe difficult to start
Hello, my atlas lathe has an old GE 110v motor. Lately it developed a difficult to start issue, especially the first use of the day. It hums, and you can feel it is trying... a lot of time, I can spin the wheel to help get it start. When it started it runs run. Should I be looking into the...- Wxm88
- Thread
- motor starting
- Replies: 5
- Forum: ALL ABOUT ELECTRICAL ISSUES