I'm pretty new at this stuff. But I've been happy with the results I've gotten turning 304SS in sizes under an inch. So I felt emboldened So when I found a 4' length of 303 round bar at the local scrap yard... But the larger diameter (even in a more machinable alloy) is not nearly as...
Hello All! I just purchased a lightly used Little Machine Shop 7x12 mini lathe, and this is my first post. Thank you in advance for any help sorting out my question/issue below.
Could anyone tell me if the PO setup the cross slide correctly? He was turning only pen sized plastic material...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.