-
Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!
leveling
-
Lathe Leveling feet
I've been working on leveling my lathe as I wait for replacement parts. My garage floor is horrible, especially RIGHT where I have my lathe of course. I have the orange cast iron feet epoxied to 1/2" by 3" flat square steel for risers. I'm needing a little more height on some, or a better way...- jareese
- Thread
- lathe feet lathe height adjustment leveling
- Replies: 46
- Forum: GENERAL HOME MACHINE SHOP DISCUSSIONS
-
X
My PM-1640TL lathe, also known as TL-1640
This thread is about my PM-1640TL also known as TL-1640 which I received in August, 2021. I had placed the order at PrecisionMatthews.com only weeks earlier. It was ordered with DRO and the taper unit installed. I was posting to the thread "PM-1660TL" which was started by @erikmannie in June...- xyz
- Thread
- cleaning hitachi wj200-075lf leveling pm-1640tl taper unit tl-1640 vfd
- Replies: 24
- Forum: PRECISION MATTHEWS - Quality Machine Tools
-
D
how to level south bend 9
The lathe is a a late 1945 South Bend 9a. It has an under motor mount. After much back and forth the lathe is installed on a new table. It is a tool room model with a free floating foot. In other words the bed is supported by 4 bolts to the casting near the head and the foot is supported by a...- dansawyer
- Thread
- leveling south bend 9
- Replies: 3
- Forum: SOUTH BEND LATHE WORKS
-
Lathe. Alignment and wear evaluation
My essay about setting up a lathe, levelling and checking against wear. [turn english subtitles on]- cascao
- Thread
- lathe leveling precision set up wear
- Replies: 1
- Forum: GENERAL HOME MACHINE SHOP DISCUSSIONS
