-
Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!
lathe taper
-
U
Saddle causing .150 taper 3” off chuck no tailstock need help.
Have a BT1337g it’s been a great lathe. Recently it’s been gaining an appreciable amount of taper to an astounding .150 thouthandths when I chuck a 5” 6061 1.5” round bar and dial it in to zero concentric. To add further clarification this isn’t a tailstock issue or a bed level issue. Bed is...- Uguessedit
- Thread
- lathe taper saddle wear
- Replies: 70
- Forum: ASIAN LATHES & MILLS