gib screws

Hi All, I am looking into fitting some sort of actuator to my mill gib locks as part of a partial automation project that I’m undertaking. The mill is a craftex cx601, essentially a grizzly g0704, and it has the standard two plastic handles to screw in two set screws per gib. I had looked at...

Morning folks, Well I got the tapered pin out of the binding post on my 10L Taper attachment but I need both gibs that are used on the bed of the attachment, itself. I am looking for a source and wondering if the cross slide gibs are the same profile but just a different length ? For...