dro installation

I'm beginning installation of a DRO on my Jet GHB-1340 Lathe and trying to way the pros and cons of mounting the carriage scale on the head-stock side vs. the tail-stock side. Carraige Scale 2 by heli_av8tor posted Nov 26, 2016 at 12:36 PM Carraige Scale 1 by heli_av8tor posted Nov 26, 2016 at...

i Purchased a 3 axis IGaging EZ-View DRO kit, it had a 24", 12" and 6" scales in the kit. for my mill , it was going to be challenging to install the Y & Z axes without modifications the X was relatively straightforward, but i decided to put it on the rear of the table- a little complication. it...

Did anyone order a PM1228 with DRO? If so could you share some pictures how it was installed please. I have a general idea how it is suppose to go but just wanted to verify where the various brackets were installed.

I Gaging DRO Installation i got the i gaging dro's for my Shenwai SW900B lathe. a close up of the scale installation, below i got the 6" cross slide (Y axis) installed and the display positioned on my vfd enclosure. to install, lay out where the scale and dro slider will fit and be...