-
Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!
drilling lathe
-
B
Drilling A Hole Vs. Milling A Hole - Bit In Lathe Tailstock
After reading a few posts on the internet I used an endmill to create a 12mm hole in a 15mm diameter piece of steel. Two flute milling cutter in jacobs chuck in tailstock of lathe. No Problem - easily and quickly done. And yet if I had gone the drilling route ie pilot hole then increasing...- BillWood
- Thread
- drilling lathe drilling speed milling lathe
- Replies: 12
- Forum: A BEGINNER'S FORUM (Learn How To Machine Here!)