bushing

  1. yearn

    [Drill] Seeking Dimensions of a part from Canedy-Otto Royal 18 Drill Press (or advice)

    All, I'm seeking some help with a question regarding my pre-WW2 Canedy-Otto Royal 18. I do realize it's been a long time since some of those who mentioned owning a Canedy/Cincinnati drill press have posted, so hopefully this still reaches a few. Also, note that I'm not sure if any of the other...
  2. D

    Recovery from mistake - how to shim one side of bush OD ?

    The project was to mill out the holes for the feed shaft of a lathe that were badly worn and then seat a bush with the proper ID. This would hold the feed shaft in alignment. The first part of the project went fine; the first hole was square and centered. However the second went south, about 1/4...
  3. D

    How to 'repair' a worn cast iron bushing ?

    Below is a photo of the feed 'shoe' from a 1956 Colchester lathe. The feed rod goes through the 'bush' and drives the gear, partially visable in the center. Over the years the feed rod has gradually worn the bushing surface into this oblong opening. I would like to repair this. The best solution...
  4. HolyHarp

    Reamers for bushing throttle shaft.

    I have a Nissan Z16 engine carburetor with a very loose throttle butterfly valve shaft. Unless someone has a better idea, I want to bush the holes. I'm looking at a bushing with a nominal OD of 10.5 mm and an ID of 8 mm. I believe I need 2 reamers for this job. I've never had occasion to use a...
  5. jrkorman

    Atlas 9-73A Sleeve 1.1

    Non Factory drawing of the change gear sleeve. Based on measurements from my Craftsman 101.07403
  6. jrkorman

    Atlas 9-70A Bushing 1.1

    Non Factory drawing of the change gear bushing. Based on measurements from my Craftsman 101.07403
  7. D

    Need a bushing/shaft extension.

    I have a motor with a 7/16" dia., 1-5/8 long shaft. I need to fit a sanding belt drive wheel to it. The drive wheel is 2-1/2 thick, w/ a 5/8 hole. Is there someone out there that would be willing to machine a bushing/shaft extension for me? It would be a 2-1/2" long shaft, 5/8 in diameter...
Back
Top