This is my version of the Atlas 618 ball crank for the tool post slide based upon drawings done by mvagusta. Rather than using a locknut on the end and a woodruff key, the handle bore will need to be tapped 1/4-20 to thread onto the tool post slide screw and then tightened against a nut...
This is my version of the Atlas 618 ball crank, carriage cross feed based upon the drawings done by mvagusta. Rather than using a locknut on the end and a woodruff key, the handle bore will need to be tapped 5/16-24 to thread onto the carriage slide screw and then tightened against a nut...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.