I made this in sketchup 18.
https://www.thingiverse.com/thing:4738659 this is my thingaverse link so you can down load stl file to make it.
If you use 40 percent or higher infill it would be strong enough to actually use on lathe.
Or...
https://www.thingiverse.com/thing:4738659 this is my thingaverse link so you can down load stl file to make it.
If you use 40 percent or higher infill it would be strong enough to actually use on lathe.
Or...
You do not have permission to view the full content of this resource.
Log in or register now.