When installing the gear(from last picture) push the pin on the back of the gear into this hole on the speed change hub.
Install the bearing block/speed change hub with the four cap screws as shown.
At this point you can reinstall the speed change hub/bearing block back into the housing.
Install the gear...this side facing you. Really this is the best time to put some gear lube on this gear.
When installing the gear(from last picture) push the pin on the back of the gear into this hole on the speed change hub.
This pin on the gear gets installed in the hole on the speed change hub. See next picture.
After cleaned it was easy to push the hub back into the bearing plate by hand. I also lightly sanded it with 600 grit paper then lightly oiled it.
The speed change hub on mine seemed tight. I removed it and cleaned it up nicely. I pressed it out. Put the nut on first so you can press on it.
expressline99

When installing the gear(from last picture) push the pin on the back of the gear into this hole on the speed change hub.

Media information

Album
Bridgeport Series 1 VS 2hp Upper belt housing tear down and rebuild
Added by
expressline99
Date added
View count
877
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/3.5
Focal length
6.3 mm
Exposure time
1/40 second(s)
ISO
400
Flash
Auto, did not fire
Filename
DSCN5694.JPG
File size
2.2 MB
Date taken
Fri, 19 May 2017 4:58 PM
Dimensions
3648px x 2736px

Share this media

Back
Top