The speed on the unit needs to be set at it's maximum. The speed change plate close to the top of the upper belt housing.
Speed change assembly showing how it should look once installed. See the chain is slightly left? The correct side of the Speed Over-limit Stop screw.
Make sure it's set to 4200...don't attach the face plate yet!.
The speed on the unit needs to be set at it's maximum. The speed change plate close to the top of the upper belt housing.
Time to install the speed indicating dial. I bought a new one the other was really worn and hard to read.
The chain from the speed change drum should be like this or have it's pivot point on the drum slightly left as you look at it.
The other end of the speed change plate has to be connected with a cotter key and a Hardened washer to the end of the plate adjusting screw.
Connect the chain to the speed change plate like this using the t-bolt and the cotter key. Be sure and bend at least one leg out on the cotter key.
expressline99

The speed on the unit needs to be set at it's maximum. The speed change plate close to the top of the upper belt housing.

Once you have the speed set at it's max. (chain fully extended on speed change drum) you can install the dial on the front of the unit as shown. The speed set to 4200 on the jack rabbit/fast/high speed side. I am only holding the cover plate up don't attach it. Tighten the dial with the nut.
Click to expand...

Media information

Album
Bridgeport Series 1 VS 2hp Upper belt housing tear down and rebuild
Added by
expressline99
Date added
View count
912
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/3.5
Focal length
6.3 mm
Exposure time
1/56 second(s)
ISO
400
Flash
Auto, did not fire
Filename
DSCN5718.JPG
File size
2.2 MB
Date taken
Fri, 19 May 2017 6:13 PM
Dimensions
3648px x 2736px

Share this media

Back
Top