Screw on the micrometer nut.
Showing the hole in the shaft aligined the way you need it for the reverse trip ball lever.
As you push the quill stop screw up make sure the hole in the end of the shaft and the hole on the right are aligned!
This is about how are you need to screw everything on before it will slide into place
Screw on the micrometer nut.
Next install the micrometer locking nut... This part takes a bit.. you have to do alot of spinning here.
Slide the retaining ring on from the top.
Slide the retaining ring on to the quill stop screw... leave loose while you install the rest of the parts.
expressline99

Screw on the micrometer nut.

I used a screw driver in the end of the screw...where the slot is cut at the bottom. Awkward but makes it faster. Just hang on to the nut and spin the end of the screw.
Click to expand...

Media information

Album
Bridgeport Series 1 VS 2hp lower end putting it back together.
Added by
expressline99
Date added
View count
533
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/5.6
Focal length
6.3 mm
Exposure time
1/60 second(s)
ISO
200
Flash
On, fired
Filename
DSCN5097.JPG
File size
2.1 MB
Date taken
Wed, 22 March 2017 6:45 PM
Dimensions
3648px x 2736px

Share this media

Back
Top