Make sure you lube the worm gear.
Time to install the handle. On mine I just had to tighten the set screw...directly over the flat spot on the shaft.
Install the wavy spring washer on the shaft next to the bronze bearing.
Wavy spring washer....remember this? Hope you didn't lose it.
Make sure you lube the worm gear.
Install the bearing block/speed change hub with the four cap screws as shown.
At this point you can reinstall the speed change hub/bearing block back into the housing.
Install the gear...this side facing you. Really this is the best time to put some gear lube on this gear.
expressline99

Make sure you lube the worm gear.

At this point I had forgotten to lube the other gear...so this took me a bit. Apply some super lube.
Click to expand...

Media information

Album
Bridgeport Series 1 VS 2hp Upper belt housing tear down and rebuild
Added by
expressline99
Date added
View count
936
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/3.5
Focal length
6.3 mm
Exposure time
1/48 second(s)
ISO
400
Flash
Auto, did not fire
Filename
DSCN5698.JPG
File size
2.2 MB
Date taken
Fri, 19 May 2017 5:09 PM
Dimensions
3648px x 2736px

Share this media

Back
Top