Install the wavy spring washer on the shaft next to the bronze bearing.
T-bolt(?) and cotter key to install the speed change plate. Yes I know I should have replaced this key.
The speed change assembly is attached to the upper belt housing using two socket head screws. The fins go towards the Bridgeport lettering.
Time to install the handle. On mine I just had to tighten the set screw...directly over the flat spot on the shaft.
Install the wavy spring washer on the shaft next to the bronze bearing.
Wavy spring washer....remember this? Hope you didn't lose it.
Make sure you lube the worm gear.
Install the bearing block/speed change hub with the four cap screws as shown.
expressline99

Install the wavy spring washer on the shaft next to the bronze bearing.

Media information

Album
Bridgeport Series 1 VS 2hp Upper belt housing tear down and rebuild
Added by
expressline99
Date added
View count
1,085
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/5.6
Focal length
6.3 mm
Exposure time
1/60 second(s)
ISO
200
Flash
Auto, fired
Filename
DSCN5701.JPG
File size
2.2 MB
Date taken
Fri, 19 May 2017 5:16 PM
Dimensions
3648px x 2736px

Share this media

Back
Top