Install the cover with the single screw...and that's it. You should be able to test at this point. Fingers crossed!
Install the cover with the single screw...and that's it. You should be able to test at this point. Fingers crossed!
The upper wires are the motor wires. The lower are the "line" wires coming in from the power source. Center screw to left is ground.
4 incoming wires.
Time to wire the reversing switch.
Wide angle of the head reinstalled! Great job if you followed me this far... long journey! Lets fix the table!
The head should look like this after being bolted on.
Install the smaller nuts and washers on the right. (all the washers are the same size.) Beveled side of the washer faces out.
expressline99

Install the cover with the single screw...and that's it. You should be able to test at this point. Fingers crossed!

Media information

Album
Bridgeport Series 1 VS 2 HP reinstall head
Added by
expressline99
Date added
View count
852
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/5.6
Focal length
6.3 mm
Exposure time
1/60 second(s)
ISO
200
Flash
Auto, fired
Filename
DSCN5992.JPG
File size
2.2 MB
Date taken
Sun, 30 July 2017 3:04 PM
Dimensions
3648px x 2736px

Share this media

Back
Top