Install the bearing block/speed change hub with the four cap screws as shown.
Install the wavy spring washer on the shaft next to the bronze bearing.
Wavy spring washer....remember this? Hope you didn't lose it.
Make sure you lube the worm gear.
Install the bearing block/speed change hub with the four cap screws as shown.
At this point you can reinstall the speed change hub/bearing block back into the housing.
Install the gear...this side facing you. Really this is the best time to put some gear lube on this gear.
When installing the gear(from last picture) push the pin on the back of the gear into this hole on the speed change hub.
expressline99

Install the bearing block/speed change hub with the four cap screws as shown.

Media information

Album
Bridgeport Series 1 VS 2hp Upper belt housing tear down and rebuild
Added by
expressline99
Date added
View count
1,085
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/3.5
Focal length
6.3 mm
Exposure time
1/58 second(s)
ISO
340
Flash
Auto, did not fire
Filename
DSCN5697.JPG
File size
2.2 MB
Date taken
Fri, 19 May 2017 5:07 PM
Dimensions
3648px x 2736px

Share this media

Back
Top