Compression springs that help the control of the bull gear movement (up and down) when shifting between High and Low speeds.
Place the washer over the springs like shown.
3 springs install...with my installer hand out of the way. lol
Install the 3 compression springs into their pockets in the gear housing. (clean and lightly lubricate.)
Compression springs that help the control of the bull gear movement (up and down) when shifting between High and Low speeds.
Side profile I cut on the lock nut socket "teeth" using a dremel with a cutoff wheel. Straight on view if you look to the back tooth.
You'll have to hold the bull gear in a way that allows you to tighten the lock nut. I clamped down with a c-clamp and a chunk of wood to the bench.
The socket fits pretty nicely into the sleeve after modifying the "teeth"
expressline99

Compression springs that help the control of the bull gear movement (up and down) when shifting between High and Low speeds.

Media information

Album
Bridgeport Series 1 VS 2hp Rebuilding the Gear Housing
Added by
expressline99
Date added
View count
582
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/3.5
Focal length
6.3 mm
Exposure time
1/33 second(s)
ISO
400
Flash
Auto, did not fire
Filename
DSCN5328.JPG
File size
2.2 MB
Date taken
Sun, 02 April 2017 6:16 PM
Dimensions
3648px x 2736px

Share this media

Back
Top