At this point you can reinstall the speed change hub/bearing block back into the housing.
Wavy spring washer....remember this? Hope you didn't lose it.
Make sure you lube the worm gear.
Install the bearing block/speed change hub with the four cap screws as shown.
At this point you can reinstall the speed change hub/bearing block back into the housing.
Install the gear...this side facing you. Really this is the best time to put some gear lube on this gear.
When installing the gear(from last picture) push the pin on the back of the gear into this hole on the speed change hub.
This pin on the gear gets installed in the hole on the speed change hub. See next picture.
expressline99

At this point you can reinstall the speed change hub/bearing block back into the housing.

Make note here. If you have the speed over-limit screw on the wrong side of stop screw on the gear.... turning the speed change handle will work but the dial won't read correctly. It may even appear to do the opposite of what you are doing with the handle. If it's not working move gear clockwise.
Click to expand...

Media information

Album
Bridgeport Series 1 VS 2hp Upper belt housing tear down and rebuild
Added by
expressline99
Date added
View count
917
Comment count
1
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/5.6
Focal length
6.3 mm
Exposure time
1/30 second(s)
ISO
200
Flash
Auto, fired
Filename
DSCN5696.JPG
File size
2.1 MB
Date taken
Fri, 19 May 2017 5:06 PM
Dimensions
3648px x 2736px

Share this media

Back
Top