- Joined
- Jan 16, 2014
- Messages
- 53
Ok, I know it is not as heavy as some, but I just had to comment on a tool when the only way to use it is to use a shop crane to get it into position.
It is a 12" Phase II H/V table with a 10" chuck and adapter on it. It seems about 270lbs according to the specs.
Any Ideas on where to drill and add a eyebolt to it for lifting?
It is a 12" Phase II H/V table with a 10" chuck and adapter on it. It seems about 270lbs according to the specs.
Any Ideas on where to drill and add a eyebolt to it for lifting?