B
Buffalo20
Forum Guest
Register Today
Yes that's the 115 volt arrangement. 230 volt only takes 3 motor wires: For the 3 wire case, one end of the start leg can be tied
to the midpoint of the series connected run windings, the other end goes to pin 3 of the drum switch. You're "flipping" one end of the start leg from one power to the other
to reverse direction.
Mark
I would be interested in your 3 wire for 230 vac comment, all 6 of the 230 vac, single phase motors, I have in the shop, need the full 4 wires. I tried it this afternoon, after I read the post, on 2 different motors, neither motor would run at all.