This is the Y GIB from my X2 size mill, everything was fine but then my Y axis began to display wiggle.
Tried to tighten them and started to bind at end of travel, decided to remove GIB and take a look.
It has a lip there on the edge of about .030
Was going to sand it flat but wanted to post here and see what might have cause it and best way to solve it.
Tried to tighten them and started to bind at end of travel, decided to remove GIB and take a look.
It has a lip there on the edge of about .030
Was going to sand it flat but wanted to post here and see what might have cause it and best way to solve it.