Tormach Superfly Question.......

[mikey]

Just got my Tormach Superfly cutter yesterday. Limited time to experiment. Tried it on a 3' wide 6061 aluminum bar. Fly cutter set at maximum width, 2000 rpm, .005 DOC, not sure on feed rate. Done on a PM30mv.

Looks pretty good there, Raven! Like I said, not a mirror but acceptable.

 

[springer]

I love the superfly. I wouldnt hesitate to buy again if I had to. I opted to keep using this vs buying a bigger face mill, not sure whatd I gain. Of course I dont do anything serious, just personal stuff

 

[Buffalo21]

Damn!! Your guys are going to make me buy one.......

 

[higgite]

Damn!! Your guys are going to make buy one.......

Then our job here is done..... next!

Tom