Tighten the part properly

Dontheo55 · Feb 15, 2023

I was in a hurry and put this part in the vise with only 1/4 inch on one side contacting the vise. All I had to do was turn the part and I would have had full contact on the vise jaws

MrWhoopee · Feb 15, 2023

We all do it, we just don't document and post it.

Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!

Tighten the part properly

Dontheo55

H-M Supporter - Silver Member

Attachments

MrWhoopee

H-M Supporter - Gold Member