- Joined
- May 17, 2012
- Messages
- 104
I just picked up a Starrett 196A1Z Universal Back Plunger Dial Indicator set at a used tool store, but it is missing the rectangular bar with the two mounting holes. If anyone has that part, I'd really appreciate it if you could post a picture of the part next to a scale so that I could make one. Or just a list of measurements might be simpler to do. It looks to be a pretty straightforward thing to make.
Here's what I think I'd need to sketch it up:
Bar Length:
Bar Width:
Bar Thickness:
Radius of Cutout below mounting point:
Length of straight section before cutout tangent point:
Height of the straight section where the rods mount:
Here's what I think I'd need to sketch it up:
Bar Length:
Bar Width:
Bar Thickness:
Radius of Cutout below mounting point:
Length of straight section before cutout tangent point:
Height of the straight section where the rods mount: