- Joined
- Nov 5, 2010
- Messages
- 871
My shaper is in good shape and ready to run for the first time in decades, but the wiring is screwed up.
The power cord goes inside the main housing to the switch, then comes out to the motor.
I'm thinking one side of the mains goes to a switch terminal, the other lead to the motor, and a wire connecting the other switch terminal to the remaining motor terminal.
Is it that simple?
The power cord goes inside the main housing to the switch, then comes out to the motor.
I'm thinking one side of the mains goes to a switch terminal, the other lead to the motor, and a wire connecting the other switch terminal to the remaining motor terminal.
Is it that simple?