- Joined
- Apr 24, 2016
- Messages
- 17
This problem has arisen recently and I have not been able to figure out the source. I was seeing a lot of movement in the cross slide while cutting and getting chatter as a result, so I adjusted the gib for a tighter fit. All was well for a few months, but now I am experiencing difficulty turning the leadscrew to move the cross slide toward the head. It binds so tightly that it is difficult to move even when not cutting. Turning the leadscrew to move the cross slide away from the head is perfectly free and normal. My lathe is about 10 years old. Could this be a signal for a new leadscrew nut?
Appreciate any and all insights.
John
Appreciate any and all insights.
John