Scissor knurl attachment question

[jwhealy]

@Ray, good point. I replaced the provided pins --- Asian cheese-steel, although they did not appear worn, they were too small out of the box---with dowel pins. Fortunately a good fit, as they are (as you point out) hard.

Did you need an arbor press to get the pins out?

 

[Video_man]

Did you need an arbor press to get the pins out?

Not hardly, if they had been that good wouldn't have been a problem. No, although they were coin-knurled on one end, a light tap from a pin punch was more than enough.

 

[TOOLMASTER]

Oxtoolco knurling demo:


http://www.youtube.com/watch?v=nsCiVpi6qAk

isn't the whole point of scissors to use them at 12 n 6 to prevent side load?