Repair 3phase electric motor(Unisaw)

Hey Mike,

Finally got the motor back in the saw and making some sawdust again. The problem was when I wired up the outlet to the RPC I mistaken the "Z" screw hole
on the outlet for the GROUND . When I took it apart I made the switch to the correct ground "W" on the outlet, it all worked fine. Well the saw needed a cleaning and some
lubrication anyway!

Regards.............Kerry
 
OOPS. We've all been there. Good Job.:thumbsup:
 
I'm glad you got it all worked out Kerry.
i figured it was a simple mistake.

look at it this way,
you now know more than 80% of people about 3 phase electric motors and RPC's:))


don't be a stranger, you can send me a private message anytime.
mike:))
 
Hi Mike,

I will , don't I need to know your e-mail to send a private message or is there another way.
Regards.............Kerry
 
you can send a private message on this forum or my regular email is
ulmadoctor@yahoo.com

i'll send you a PM and maybe you can see how it works.
if nothing else you can just hit the reply button to the PM i send you
mike
 
Back
Top