Question On Installing A 3 Phase Motor On A Go602..?

DBlue

Registered
Registered
Joined
Mar 8, 2013
Messages
30
I have a Go602 lathe would like to install a 3 phase motor with a VFD. Which motor and VFD should I get. I know a little electrical but know nothing about doing this conversion. If anyone could give me some help I would really appreciate it....

Thanks,
Don
 
There are a number of postings describing the conversion, the motor is metric, so would go with look at something like a Leeson Metric series D80 frame, but would need to verify what your lathe came with. Teco makes some very nice basic VFDs, the current low end would be a L510 with 115V single phase in 230 three phase out. Also look at AutomationDirect GS2 or GS3 models. Just a starting point.

http://www.projectsinmetal.com/foru...install-a-vfd-on-a-grizzly-g0602-10x22-lathe/
http://www.wolfautomation.com/produ...1-to-3-hp-single-or-3-phasebrteco-l510-series
 
Back
Top