Project: New drawbar for my benchtop mill.

schor

Registered
Registered
Joined
Jun 11, 2013
Messages
731
I made a new drawbar for my benchtop mill. The whole project is covered in 6 minutes of video, most of it fast motion of my th54 lathe doing most of the actual work.

There are other ways to make a drawbar than turning it from solid hex stock, but I had some kicking around and I wanted to create some chips.

I knew the lathe was going to do most of the work, so taking video was pretty easy. Its the editing that takes all the time for a project.

 
Last edited by a moderator:
Great job Steve, it must have taken some time and effort to make this video, edit.add music ,etc. but you made it work.
 
I had hours of video to edit. Then I changed the music 3 times. Thanks for the comps.
 
Back
Top