Precision matthews pm932m owners

U

umahunter

Forum Guest
Register Today
I'm about to order a 932m and I was wondering from other owners how was traming on your first set up fit and finish wise did you need to shim the column to tram in square with the table like round column mill drills ???
 
I'm about to order a 932m and I was wondering from other owners how was traming on your first set up fit and finish wise did you need to shim the column to tram in square with the table like round column mill drills ???

I had to shim the column on my PM-932. It's been a few years but it wasn't much of a shim, maybe .002 to .003. FWIW when I adjusted the Z axis gib and checked the spindle centerline to the table in the Y axis it was within .002. Not bad!
 
Back
Top