- Joined
- Apr 6, 2011
- Messages
- 2,082
I just picked up a 6" lathe chuck off e-bay. It's a nice tight little chuck and looks like it has little to no use. It has had a bath in Evaporust to remove some slight surface rust and I've scraped out some hard, dried grease from a couple of the slots so I'm pretty sure it's been sitting for a while.
I've been looking for information on the company/chuck but I'm not having much luck. The brand is "Pratt" but I don't believe it's related to the "Pratt-Burnerd" stuff at all as this chuck is marked "Made in England".
I was looking for a chuck to replace the beat up, finicky, Chicom one that I have now. Saw this 6" that was in very nice shape so put a medium/low bid on it now here it is. I'm not sure just how I'm going to put it to use as it turned out to be a bit more "petite" than I had figured.
Haven't turned up any information on a Pratt chuck from England though so I'd be interested in what anyone has to offer.
Thanks much,
-Ron
I've been looking for information on the company/chuck but I'm not having much luck. The brand is "Pratt" but I don't believe it's related to the "Pratt-Burnerd" stuff at all as this chuck is marked "Made in England".
I was looking for a chuck to replace the beat up, finicky, Chicom one that I have now. Saw this 6" that was in very nice shape so put a medium/low bid on it now here it is. I'm not sure just how I'm going to put it to use as it turned out to be a bit more "petite" than I had figured.
Haven't turned up any information on a Pratt chuck from England though so I'd be interested in what anyone has to offer.
Thanks much,
-Ron