- Joined
- Apr 12, 2016
- Messages
- 53
I have finally fired up my new mill and immediately run into an issue.
When I ordered the mill, I got a starter package with collet set. I assumed that the Collets should fit the mill. However, none of the collets seat deep enough to engage the drawbar. I know there is a keyway cut into the collet body, but it doesn't seem to be large enough for the key. The drill chuck that came with the mill goes in just fine all the way, but the collets will not.
Am I missing something? Is there some kind of the adjustment to make it work?
Sent from my SM-G930V using Tapatalk
When I ordered the mill, I got a starter package with collet set. I assumed that the Collets should fit the mill. However, none of the collets seat deep enough to engage the drawbar. I know there is a keyway cut into the collet body, but it doesn't seem to be large enough for the key. The drill chuck that came with the mill goes in just fine all the way, but the collets will not.
Am I missing something? Is there some kind of the adjustment to make it work?
Sent from my SM-G930V using Tapatalk