PM-45M-CNC Setup and Configuration with Mach3

I am very happy to hear that you got things working. Looking forward to seeing what you make with it. I have been very happy with mine. Big enough accurate enough for the things I do.
 
Boswell said:
I am very happy to hear that you got things working. Looking forward to seeing what you make with it. I have been very happy with mine. Big enough accurate enough for the things I do.
Click to expand...
Question though on the spindle for the wires numbered 17 are yours connected together or are they just taped up

Also what pin & ports motor outputs would your spindle be is it 16 and 14
 
My notes say that the spindle wires were as follows
Spindle CCWwire number G-85Attached to PMDX-107 SP6
Spindle CWWire number R-83Attached to PMDX-107 SP5
Spindle CommonWire number W-0V (zero volt?)Attached to PMDX-107 SP4
Spindle 0-10VWire number 81? not sure my notes don't list this


Here is a bad quality picture of the wires attached to the PMDX-107
20160717_194829.jpg
 
You must log in or register to reply here.
Back
Top