• This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn more.
  • PLEASE: Read the FORUM RULES BEFORE registering!

Pay Attention, No Distractions Please.

FLguy

H-M Supporter - Premium Content
H-M Supporter-Premium
#1
I was finishing cutting dovetails for a tangential toolholder to fit a QCTP. A pending trip popped into my mind just when I was taking my final cut, ##!!. Oversized it. I'm still upset with my self and at my age I ought to know, always have a one track mind for only what your machining. Well being retired a guess I have time for a due-over.
 

kingmt01

Active Member
Active Member
#4
Make two at the same time this tone if they both make it so the way to finish I'll take one. I've been wanting one myself & would even give you one of my stories for it. Lol

Can you just oversize it a bit more & make a shim to weld in it?
 

FLguy

H-M Supporter - Premium Content
H-M Supporter-Premium
#5
Make two at the same time this tone if they both make it so the way to finish I'll take one. I've been wanting one myself & would even give you one of my stories for it. Lol

Can you just oversize it a bit more & make a shim to weld in it?
Ah,yes but the 2nd one is fine. I may dig the first one out from the odds and ends bin and do just that. Thanks