- Joined
- Aug 4, 2015
- Messages
- 291
Yep. Had one of those days.
Couldn't get a correct set of edges on any of the end mills I worked on sharpening.
Found out that my mill is not only in need of tramming but the vice has shifted and is not square with the table so it cuts tapers.
All this for a toe jack to set a lathe off the skates int been on for 3 months so I can then begin leveling it.
Good stuff.
Hoping for a better day tomorrow.
Couldn't get a correct set of edges on any of the end mills I worked on sharpening.
Found out that my mill is not only in need of tramming but the vice has shifted and is not square with the table so it cuts tapers.
All this for a toe jack to set a lathe off the skates int been on for 3 months so I can then begin leveling it.
Good stuff.
Hoping for a better day tomorrow.