How far out of the chuck did you have the work piece sticking? That and tool height can be part of your issue.
Did the HSS give you a better finish than the carbide?
Tool bit out too far.. Yes, that and length of part. Turned to ½ by 10” long or so would be a long part and tend to chatter with needing a very sharp bit and light feed and depth of cut or a steady.
Do keep posting you finding about your Smithy 1237
.001 for a 3 jaw is not bad at all.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.