Need Help Replacing Motor On Enco 110-2075 Engine Lathe

Hello Gentlemen,

Just a last note to close out.
The acquired Chinese motor had a junction box identical to the one I took out. I hooked it right up and it ran fine. I did need to switch the hot leads as it was running backwards, but it is working great.

Thanks again for all the time and effort you all gave to my puzzle, it is great that you give this support.

The Baldor will become a 12" or 20" disc sander I believe, or perhaps a combo disc and belt sander.

Sincerely,

CannonFodder (Robert)
 
Back
Top